When the vulcanizing machine is in use, there will be more or less bumps, but during the collision, the water pressure plate appears to seep, and it should be checked according to the following steps:
1. Check whether the water seepage part is the surface of the hydraulic pressure plate or the contact area of the surrounding rubber with the lower plate of the hydraulic pressure plate. If there is leakage in the surrounding gap, all the surrounding screws should be tightened in order.
2. If the leaking part is the surface of the rubber plate of the hydraulic pressure plate and the leaking part is needle-shaped, in the case of emergency repair, you can use 520 glue to repair, but the panel must be replaced after the emergency repair.
3. In case of serious water leakage, it cannot be used and the water pressure plate must be replaced.
The above three points are the solutions to the water leakage after the vulcanizing machine bumps. I hope it will be useful to you. Usually, you should pay attention to the maintenance and maintenance of the vulcanizing machine, and try to avoid similar situations.
